PLASTIC MATERIALS INDUSTRY

EASY AND LOW-COST INSTALLATION

 

The 40mm-thick, 7 walls design with tongue and groove connection gives the panels remarkable flexural strength.

It also allows the panels to be installed without the use of metal reinforcement frames (continuous glazing), thus eliminating heat loss due to the thermal bridges caused by these structures (discontinuous glazing). For installations exceeding 2.2m, a suitable section-breaker profile must be installed to which the arcoPlus® panels can then be fixed. This is done using the specific brackets to give the system the necessary resistance to negative wind load and permit sliding due to thermal expansion (see load resistance graph). 

Insertion of plate

Insertion of aluminium plates for

anchorage to existing structures.

Side profile

Detail base profile TT with eave in AL

base profile with tt

Detail side profile TT in AL

 

Calculation and installation examples of panel length (PL)

Warning: for height more than 9 m, please contact our technical service:

VIDEO INSTALLATION

OUTSIDE OF THE BUILDING

 

H window 20 = A+80mm
H window 40 = A+95mm

 

WITH EAVE
WITH FRONTAL OPENING


H window 20 = A-50mm
H window 40 = A-50mm

H window 40 = A-60mm(TT)

WITHOUT EAVE


H window 20 = A-40mm
H window 40 = A-45mm

H window 40 = A-60mm(TT)